I signed the PO for our office lighting retrofit in March 2024. The shortlist came down to two options: keep our existing manual switches and add plug-in timers, or go with a Legrand system—occupancy sensor switches, LED dimmers, and a Zigbee-connected gateway tying it together.
I'm the office administrator for a 180-person company. I manage facilities ordering—roughly $140,000 a year across 12 vendors—and I report to both operations and finance. I'm not an electrician. I don't design circuits. But I'm the person who signs the invoice, fields the complaints, and explains to my VP why the lights in the east conference room are doing something weird again.
So when the retrofit came up, I compared the two options on five dimensions that actually matter after the installers leave: upfront cost, installation friction, maintenance, employee satisfaction, and expansion. Here's the comparison, with the numbers I can actually verify.
The Comparison Framework
Option A was traditional: manual wall switches, a few plug-in timers, and standard LED bulbs. Option B was the Legrand setup: occupancy sensors in common areas, Legrand LED dimmers in the meeting rooms, and a Zigbee gateway tying everything together.
I'm not going to pretend these are the only two choices. They aren't. But they're the two our electrician could quote quickly, and they represent the real fork most facilities admins face: pay less now, or pay for controls. That's the whole comparison in one sentence.
Dimension 1: Upfront Cost vs. Total Cost
The traditional quote came in at $4,800. The Legrand quote was $6,900—about 40% higher. Finance saw the first number and asked why we were even discussing the second.
Fair question. So I asked our electrician to break down what happens after year one.
The traditional switches were $18 each. Cheap. But in our building, "manual switch" means the cleaning crew leaves the break room lights on until 11 p.m. because nobody wants to walk back and flip a switch. We'd also been replacing failed LED bulbs in the lobby every few months—not because the bulbs were bad, but because they ran 14 hours a day.
The Legrand occupancy sensors shut lights off after 15 minutes of no motion. The LED dimmer Legrand sent us—the radiant series—cuts output to 60% in rooms with good daylight. I can't give you a precise energy savings percentage. Our meter data is too noisy, and I don't trust a clean number. What I can verify: bulb replacement orders dropped from roughly 30 a quarter to 12, and after-hours callouts for "lights won't turn off" went to zero.
That last one is worth more than it sounds. A single after-hours callout is $180 minimum. We had four in the year before the retrofit. That's $720 back already.
Here's the surprise. Everything I'd read about smart lighting said the premium option always pays for itself in a year. In practice, ours didn't. It took about 19 months to break even on the hardware difference, counting bulb savings, callout savings, and reduced cleaning overtime. Not bad. Not magic.
Dimension 2: Installation and Commissioning
Traditional switches: our electrician had them in by lunch. Done.
Legrand: two days for 14 rooms. Day one was wiring. Day two was commissioning—pairing each sensor to the gateway, setting sensitivity, adjusting timeout values. The Legrand occupancy sensor switch manual was the deciding factor. Not because it was great—it wasn't. But it was readable. The commissioning steps were on page 4, not buried in a 60-page PDF.
I'm not qualified to evaluate the wiring. That's the electrician's call. What I can tell you is that the sensors paired with our gateway without a single failed handshake, and the system came up on the first try.
The technical detail that mattered to our IT lead: the sensors use a Zigbee HA (Home Automation) profile, which meant we weren't locked into one vendor's ecosystem. The MCU Zigbee stack inside the sensor—the microcontroller handling the wireless protocol—wasn't something I evaluated. That's above my pay grade. But IT confirmed the devices were interoperable with our existing building management gateway, which was the whole point.
Dimension 3: Maintenance and Troubleshooting
This is where the two options diverge more than I expected.
Two months after the retrofit, the emergency light in the first-floor hallway started flashing. Every 30 seconds. "Why is my emergency light flashing" was literally the search I ran at 7:40 a.m. before anyone else got in.
Under our old setup, that would've meant a call to the electrician, a two-hour diagnostic visit, and a bill. Instead, the Legrand gateway app showed a logged fault: "Emergency light self-test failed—battery backup low." The manual's troubleshooting appendix confirmed it was the battery, not the circuit. We swapped the battery for $38 and the flashing stopped.
Now, I won't pretend the app was perfect. The fault description was vague the first time, and the troubleshooting section was in an appendix, not the main maintenance chapter. I spent 20 minutes looking in the wrong place. But 20 minutes beats two hours and a $200 invoice.
With traditional switches, you get no diagnostics. You get a symptom and a phone call. That's fine until you're the one explaining to finance why the "cheap" lighting keeps generating maintenance tickets.
Dimension 4: Employee Satisfaction
Meeting rooms were the biggest complaint under the old setup. People wanted dimmer light for presentations, brighter light for whiteboard sessions, and nobody wanted to walk to the wall to adjust it.
The Legrand LED dimmers solved that—each room has a wall control with a rotary dimmer, and the occupancy sensor handles on/off. Employees adjusted. Some rooms needed a sensitivity tweak because the sensor kept turning off on people who sit still during long calls. Two service visits. Not ideal, but workable.
The electrician warned me that mounting a sensor too close to the HVAC vent would cause false reads. I didn't listen. We moved it two weeks later. A lesson learned at the cost of one invoice.
Dimension 5: Expansion
Traditional: adding a room means running wire and adding a switch. $300–$500 per room, depending on the run.
Legrand: adding a sensor means pairing a new device to the gateway. $80 for the sensor, maybe 15 minutes of labor. We added coverage in the warehouse with a third-party Zigbee sensor—not even a Legrand part—and it paired to the gateway without complaint. That's the Zigbee HA interoperability paying off in a way I didn't expect to actually use.
Which One Should You Pick?
If you're a small office—under 20 people—on a short lease, or with a landlord who won't approve fixture changes: go traditional. Add timers where you can. The Legrand system is overkill for a space you might leave in two years.
If you own your building, have 50+ people, and plan to stay put: the total-cost math favors Legrand—but only if you actually count the maintenance calls and the bulb orders. The sticker price is 40% higher. The 19-month payback only works if you're honest about the hidden line items.
Looking back, I should have run this comparison before our 2022 partial retrofit. We spent that round patching traditional switches and eating the callouts. At the time, I didn't have the maintenance data to make the case. Now I do.
Bottom line: the cheapest quote wasn't the lowest cost. But "smart" isn't automatically better, either. Match the system to how your building actually gets used—not to what the brochure says it should be.
